WINEGARD®
Installation Instructions
Models DS-1111, VM-1111
INSTALLATION OF THIS MOUNT NEAR POWER LINES IS DANGEROUS. FOR YOUR
SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
S-PIPE
NOTE: THIS MOUNT IS NOT DESIGNED FOR
APPLICATIONS ON A VERTICAL SURFACE
SUCH AS WALLS, POLES, ETC.
CAUTION: LIMIT SIZE OF TV ANTENNA TO
GS-1000/2000, MS-1000/2000 OR A BOOM
LENGTH OF 40” OR LESS.
STEP 1. Assemble satellite dish and mount per
manufacturers instructions. Do not make fine tun-
ing adjustment at this time.
CARRIAGE BOLTS
1/4-20 x 1.25”
STEP 2. Remove (2) clamp tightening carriage
bolts from existing clamp bracket.
1/4-20
HEX NUTS
STEP 3. Attach flat plate to existing clamp bracket
with 1/4 - 20 x 1.25” bolts and install the washers
and nuts.
NEW CLAMP
BRACKET
EXISTING
CLAMP
BRACKET
1/4” WASHERS
STEP 4. Adjust azimuth and elevation on satellite
dish for optimum signal strength per manufactur-
ers instructions.
EXISTING
CLAMP BRACKET
Figure 1
STEP 5. Tighten all hardware on satellite antenna
mount, including clamp bolt nuts, when the opti-
mum signal strength is achieved.
S-PIPE
STEP 6. Slide S-pipe into new clamp, and adjust
to the approximate desired location. See Figure 2
for complete assembly.
FLAT
PLATE
CARRIAGE BOLTS
1/4-20 x 1.25”
STEP 7. Mount off-air antenna to upper mast. Run
coax downlead and secure it at the same time the
DSS wires are installed.
NEW CLAMP
BRACKET
MAKE SURE TO GROUND BOTH ANTENNA/
MOUNTS PER SATELLITE AND OFF-AIR AN-
TENNA INSTALLATION INSTRUCTIONS.
Figure 2
WINEGARD®
Printed in U.S.A.
Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601-2000
© Winegard Company 2001
2451765 Rev. 1/04
|