Automatic Multi-Satellite TV Antenna
Replacement Back-up and Feed Arm
Assembly with LNB and Coax Cable
Instruction Manual
for Model RP-SK95
For help, email [email protected] or call 1-800-788-4417
2452290
4
5
If there is not already a line marking the top of the stiffener plate, draw
a line on the stiffener plate to mark the top of the plate.
Raising the Antenna
1 Press and hold “POWER” for two seconds to turn on the interface
box. Wait until the interface box finishes “connecting to antenna.” The
TRAV’LER® antenna may enter the search routine after ten seconds.
Using a ½″ wrench, loosen and remove the four bolts holding the
reflector bracket and stiffener plate to the skew housing. At the same
time, carefully remove the stiffener plate and LNB arm assembly. Set
aside the stiffener plate and four bolts; you will need these later.
Pay attention to the pinch points as the antenna raises!
2 Wait until the antenna has at least raised to a position in which the
LNB arm is parallel to the roof. Then, press “POWER” and “SELECT” at
the same time. The antenna should stop moving.
Reflector bracket
Stiffener plate
Unplug the interface box.
3
Removing the LNB Assembly
Remove the four reflector nuts and bolts with a ½″ wrench, and
remove the reflector. Set the reflector, reflector nuts, and reflector
bolts aside; you will need these later.
Cable harness
Bolts holding reflector bracket and
stiffener plate to skew housing
(one not shown)
1
Installing the Replacement LNB Assembly
Identify the fourth outer hole in the adapter plate. The fourth hole
marks the bottom of the adapter plate.
2 Disconnect the coaxial cable from port C on the top of the turret.
1
7
Adapter plate
8
6
5
1
Turret
Coax cable disconnected
from port C of turret
2
4
3
Numbered outer holes
in adapter plate
3 Using a 5/16″ wrench, remove the screw holding the p-clamp to the lift
arm, and detach the p-clamp from the lift arm. Set the screw aside;
you will need this later.
Note: as the antenna raises and turns, the adapter plate may become
skewed, and the fourth hole may not be directly at the bottom of the
plate. If unsure of the fourth hole, remove the four screws from the center
of the adapter plate; a small post is located directly above the fourth hole.
8
7
1
3
6
2
Cable harness
5
Approximate location of
post on back side of plate
Hole in lift arm for
cable harness
4
|